Hi there, I'm trying out Synplant 2 and it's fantastic! Something I can't figure out is how to change the growth modulation amount for a particular parameter in the DNA editor.
I see the parameters change with their modulation strips on the parameter circles in the controls on the right and I can see the modulation vary on each of the DNA "ladders" on the left.
However, I can't figure out how to set those modulation ranges.
Any ideas? Thank you!
I don't think you can actually. Would be good if you could, but very complex for all the parameters.
Ah that's a bit disappointing but thanks for the info.
I've found that it's easy to end up with patches that have some less good middle states. So while sweeping from no growth, to growth max, you might encounter some "dead zones" that must be worked around.
This could be mitigated by allowing modulation ranges & midpoints.
You need to be signed in to post a reply