Trigger your Plant test


Every key that you play on the Keyboard will trigger a unique setting of parameters and send them to your Synplant.
Every Knob has a green light on the left side and a green light on the right side.
The left is to enable if the Knob should RECEIVE parameter changes that are stored on the Keyboard.
Usefull if you want to check a parameter setting at a specific key WITHOUT sending the trigger to the Plant.
The right light shows you if the Knob will SEND the parameters out (green) or not (grey).
To save a parameter setting just press the Keyboard Key where you want to save the setting.
Then turn the knobs and make the parameter changes you like. If you are ready, just press another key and repeat
the procedure. 

Philipp Ruppel
